|
|
|
|
Dental floss
|
| |
|
| |
Dental floss is either a bundle of thin nylon filaments or a plastic (teflon or polyethylene) ribbon used to remove food and dental plaque from teeth. The floss is gently inserted between the teeth and scraped along the teeth sides, especially close to the gums.
Discussion
Ask a question about 'Dental floss' Start a new discussion about 'Dental floss' Answer questions from other users |
Recent Posts
Encyclopedia
Dental floss is either a bundle of thin nylon filaments or a plastic (teflon or polyethylene) ribbon used to remove food and dental plaque from teeth. The floss is gently inserted between the teeth and scraped along the teeth sides, especially close to the gums. Dental floss may be flavored or unflavored, and waxed or unwaxed.
History
Levi Spear Parmly, a dentist from New Orleans, is credited with inventing the first form of dental floss. He had been recommending that people should clean their teeth with silk floss since 1815.
Dental floss was still unavailable to the consumer until the Codman and Shurtleft company started producing human-usable unwaxed silk floss in 1882. In 1898, the Johnson & Johnson Corporation received the first patent for dental floss. Other early brands included Red Cross, Salter Sill Co. and Brunswick.
A character is depicted using dental floss in James Joyce's famous novel
Ulysses (serialised 1918-1920) - an early mention of the practice in literary fiction.
The adoption of floss was poor before World War II. It was around this time, however, that Dr. Charles C. Bass developed nylon floss. Nylon floss was found to be better than silk because of its greater abrasion resistance and elasticity. In response to environmental concerns, dental floss made from biodegradable materials is now available.
Dentists and dental hygienists urge the daily oral hygiene regimen of toothbrushing and flossing. Nearly all Americans brush their teeth. However, the ADA indicates that only about 12 percent of Americans floss daily, 39 percent floss less than daily, and 49 percent do not floss at all.
Use
Dental floss is commonly supplied in plastic dispensers that contain 10 to 50 meters of floss. After pulling out the desired amount, the floss is pulled against a small protected blade in the dispenser to sever it.
Dental floss is held between the fingers. The floss is guided between each tooth and under the gumline to remove particles of food stuck between teeth and dento-bacterial plaque and adhered to such dental surfaces. Ideally using a C-shape, the floss is curved around a tooth and placed under the gumline, and then moved away from the gumline, the floss scrapes the side of each tooth, and can also clean the front or back of the tooth. Gently moving the floss from below the gumline to away from the gumline removes dento-bacterial plaque attached to teeth surfaces above and below the gumline. A clean section of floss can be used to clean each tooth to avoid transmitting plaque bacteria from one tooth to another.
Specialized plastic wands, or floss picks, have been produced to hold the floss. These may be attached to or separate from a floss dispenser. While not pinching the finger, using a wand may be awkward and also make it difficult to floss at all the angles possible with a finger. At the same time, the enhanced reach can make flossing the back teeth easier. These types of flossers may be missing the area under the gum line that needs to be flossed.
Occasional flossing and/or improper flossing can typically lead to bleeding gums. The main cause of the bleeding is inflammation of the gingival tissue due to gingivitis.
Directions
The advises to floss once or more per day after brushing your teeth. It should be noted that overly vigorous or incorrect flossing can result in gum tissue damage. For proper flossing, the Association advises to curve the floss against the side of the tooth in a 'C' shape, and then to wipe the tooth from under the gumline (very gently) to the tip two or three times, repeated on adjacent and subsequent teeth.
Dental floss does not clean the interproximal areas beneath the contact point, because the area is concave.
Vibration
Some power flossers utilize vibration which transfers through the floss, originating from the ends. This is likely inspired by the similar use of vibration of the bristles in modern electric toothbrushes. As the vibration causes subtle movement, the floss will find the path of least resistance when pressed down. The movement would also help in temporarily separating tooth and gum for floss to get through.
This allows easier penetration under the gumline, with less force applied to push into the gap between teeth. With less force applied, more control of flossing is possible. In normal flossing, pressure may be applied until the floss 'pops' through the teeth, and the momentum can carry on and painfully impact the gum tissue. With more control, this can be reduced or avoided totally.
Many consider vibrations to be soothing; it is a common technique in massage and orthopedic devices. Much like electric toothbrushes are soothing to the teeth and gums, vibrating floss can sooth and massage the gumline.
Cuts become less likely as the floss will not press against as isolated an area, and less pressure is applied. Any abrasions to the gum would be more evenly distributed, leading to more equal adaptation of the tissue.
Benefits
Flossing in combination with toothbrushing can prevent gum disease, halitosis, and dental caries.
See also
External links
|
| |
|
|
.jpg)
