Steam devil
Encyclopedia
A steam devil is a small, weak whirlwind
over water (or sometimes wet land) that has drawn fog into the vortex
, thus rendering it visible. They form over large lakes and oceans during cold air outbreaks while the water is still relatively warm, and can be an important mechanism in vertically transporting moisture.
Smaller steam devils and steam whirls can form over geyser basins even in warm weather because of the very high water temperatures. Although steam devils are generally quite a rare phenomenon, hot springs in Yellowstone Park produce them on a daily basis.
These phenomena have only been reported and studied since the 1970s.
in January 1971. This month was a particularly cold one for Wisconsin
(one of the coldest in the 20th century) which, combined with Lake Michigan staying mostly ice-free, produced good conditions for steam devil formation. Lyons and Pease named steam devils by comparison to the dust devil
s on land to which they have a comparable size and structure. They were also motivated by the need to distinguish steam devils from the much more powerful water spout whose land equivalent is the tornado
. Lyons and Pease wrote their article with the aim of persuading the National Oceanic and Atmospheric Administration
to include steam devils in the International Field Year for the Great Lakes which was imminently to occur in 1972-3.
s of geyser
basins. In these cases typical dimensions are a metre or so diameter, but can vary from less than 0.1 to 2 metres, and a height of 2 to 30 metres with a somewhat faster rotation of 60 rpm or so. The central core of the steam devil can be clear, in the same sense that the centre of a dust devil is clear of dust. The core is around 10% of the width of the rotating column. The sky above the steam devils may be clear, or there may be cumulus cloud
s present. In some cases the steam devils may rise directly into the cumulus, in these cases the cumulus may actually be caused by the steam devils - see below. Steam devils are a rare and short-lived phenomenon, typically surviving no more than three or four minutes, and the smaller ones over hot springs dissipating in a matter of seconds.
Steam devils can become detached from their base and be blown downstream by the wind. On small bodies of water such as hot springs this can mean that the steam devil ends up over land away from the water altogether. Such steam devils will continue to rotate even after they have become detached from the source of heat, but will soon dissipate.
Very small steam devils may have a poorly defined column and no identifiable clear inner core. Such vortices are more properly called steam whirls by analogy with the dust whirls of land.
For steam devils to form the air above the body of water must be very cold, and a fairly brisk (over 25 mph) wind of dry air needs to be blowing across the surface of the water. The temperature difference between the water and the air needs to be quite marked; the steam devils in figure 1 were forming with an air temperature of -21°C (-6°F) and a water temperature of 0.5°C (33°F) - a difference of 22°C (39°F). Under these conditions the air rises so energetically that the air flow becomes unstable and vortices start to form. Fog streamers drawn into the vortices render the vortices visible and they then become steam devils.
The steam fog tends to form irregular hexagonal cells in the horizontal plane which are elongated in the direction of the wind. In this honeycomb
arrangement, three cells will meet at a junction, and it is in these places that the steam devils form. This effect is an example of vertex vortices.
The layer of cumulus seen above steam devils during cold air outbreaks on Lake Michigan and elsewhere may not be coincidental. Airborne radar studies during cold air outbreaks on the lake have shown that some steam devils penetrate through the thermal internal boundary layer (below which convective circulation takes place) and may be more significant for thermal mixing than normal convection, transporting moist air vertically above the convection boundary. The resulting large scale view is a layer of arctic steam fog close to the water surface, a layer of cumulus just above the convection boundary and a regular array of steam devils joining the two.
in early winter. They occur in the Atlantic off the coast of the Carolinas when cold air from the continent blows across the Gulf Stream
. Steam devils can occur on small lakes and even over hot springs, but rather more rarely than on large bodies of water. It is also possible for steam devils to form over wet land if the air is cold and the sun is heating the ground.
Small steam devils occur at some of the larger hot springs in Yellowstone Park where a layer of steam fog hangs over the pools and wind can start to lift it up into fog streamers. One such example is the Grand Prismatic Spring
in the Yellowstone Midway Geyser Basin. The air temperature can be high in terms of human comfort when the steam devils form. In 1982 a cluster of seventeen steam devils was observed when the air temperature was between 17 and 21°C. Although this is much higher than, for instance, the temperature of the air over the Great Lakes, the water temperature is also proportionately higher, being very close to boiling, so the temperature difference is still 79°C.
Another well known location in Yellowstone, the Old Faithful geyser, produces horizontal steam devils. In all, Yellowstone probably has the most frequent occurrences of accessible steam devils anywhere, with several steam devils being produced every hour at the most productive locations. Steam devils over geyser basins were first reported by Holle in 1977.
Whirlwind (atmospheric phenomenon)
A whirlwind is a weather phenomenon in which a vortex of wind forms due to instabilities and turbulence created by heating and flow gradients. Whirlwinds occur all over the world and in any season....
over water (or sometimes wet land) that has drawn fog into the vortex
Vortex
A vortex is a spinning, often turbulent,flow of fluid. Any spiral motion with closed streamlines is vortex flow. The motion of the fluid swirling rapidly around a center is called a vortex...
, thus rendering it visible. They form over large lakes and oceans during cold air outbreaks while the water is still relatively warm, and can be an important mechanism in vertically transporting moisture.
Smaller steam devils and steam whirls can form over geyser basins even in warm weather because of the very high water temperatures. Although steam devils are generally quite a rare phenomenon, hot springs in Yellowstone Park produce them on a daily basis.
These phenomena have only been reported and studied since the 1970s.
Naming
Steam devils were first reported by Lyons and Pease in 1972 concerning their observations of Lake MichiganLake Michigan
Lake Michigan is one of the five Great Lakes of North America and the only one located entirely within the United States. It is the second largest of the Great Lakes by volume and the third largest by surface area, after Lake Superior and Lake Huron...
in January 1971. This month was a particularly cold one for Wisconsin
Wisconsin
Wisconsin is a U.S. state located in the north-central United States and is part of the Midwest. It is bordered by Minnesota to the west, Iowa to the southwest, Illinois to the south, Lake Michigan to the east, Michigan to the northeast, and Lake Superior to the north. Wisconsin's capital is...
(one of the coldest in the 20th century) which, combined with Lake Michigan staying mostly ice-free, produced good conditions for steam devil formation. Lyons and Pease named steam devils by comparison to the dust devil
Dust devil
A dust devil is a strong, well-formed, and relatively long-lived whirlwind, ranging from small to large . The primary vertical motion is upward...
s on land to which they have a comparable size and structure. They were also motivated by the need to distinguish steam devils from the much more powerful water spout whose land equivalent is the tornado
Tornado
A tornado is a violent, dangerous, rotating column of air that is in contact with both the surface of the earth and a cumulonimbus cloud or, in rare cases, the base of a cumulus cloud. They are often referred to as a twister or a cyclone, although the word cyclone is used in meteorology in a wider...
. Lyons and Pease wrote their article with the aim of persuading the National Oceanic and Atmospheric Administration
National Oceanic and Atmospheric Administration
The National Oceanic and Atmospheric Administration , pronounced , like "noah", is a scientific agency within the United States Department of Commerce focused on the conditions of the oceans and the atmosphere...
to include steam devils in the International Field Year for the Great Lakes which was imminently to occur in 1972-3.
Appearance
Steam devils are vortices typically about 50 to 200 metres in diameter, essentially vertical, and up to 500 metres high. The general shape is like a small waterspout but they should not be considered related. Steam devils rotate with a cyclonic direction of motion, but not very fast or powerfully, usually just a few rotations per minute, and sometimes apparently not at all. There is usually a well-defined inner part of the rotating column of steam and a more ragged outer part from which clumps of steam will often detach. Rather smaller steam devils can form over small lakes, especially the warm water in the hot springHot spring
A hot spring is a spring that is produced by the emergence of geothermally heated groundwater from the Earth's crust. There are geothermal hot springs in many locations all over the crust of the earth.-Definitions:...
s of geyser
Geyser
A geyser is a spring characterized by intermittent discharge of water ejected turbulently and accompanied by a vapour phase . The word geyser comes from Geysir, the name of an erupting spring at Haukadalur, Iceland; that name, in turn, comes from the Icelandic verb geysa, "to gush", the verb...
basins. In these cases typical dimensions are a metre or so diameter, but can vary from less than 0.1 to 2 metres, and a height of 2 to 30 metres with a somewhat faster rotation of 60 rpm or so. The central core of the steam devil can be clear, in the same sense that the centre of a dust devil is clear of dust. The core is around 10% of the width of the rotating column. The sky above the steam devils may be clear, or there may be cumulus cloud
Cumulus cloud
Cumulus clouds are a type of cloud with noticeable vertical development and clearly defined edges. Cumulus means "heap" or "pile" in Latin. They are often described as "puffy" or "cotton-like" in appearance. Cumulus clouds may appear alone, in lines, or in clusters...
s present. In some cases the steam devils may rise directly into the cumulus, in these cases the cumulus may actually be caused by the steam devils - see below. Steam devils are a rare and short-lived phenomenon, typically surviving no more than three or four minutes, and the smaller ones over hot springs dissipating in a matter of seconds.
Steam devils can become detached from their base and be blown downstream by the wind. On small bodies of water such as hot springs this can mean that the steam devil ends up over land away from the water altogether. Such steam devils will continue to rotate even after they have become detached from the source of heat, but will soon dissipate.
Very small steam devils may have a poorly defined column and no identifiable clear inner core. Such vortices are more properly called steam whirls by analogy with the dust whirls of land.
Formation
A precondition for the formation of steam devils is the presence of a layer of moist air on the water with the misty air (called arctic steam fog) being drawn upwards into fog streamers. For this to happen the body of water must be unfrozen, and thus relatively warm, and there must be some wind of cold, dry air to form the fog. The cold air is warmed by the water and is humidified by evaporation. The warmed air begins to rise, and as it does so is cooled adiabatically by the falling pressure causing the water vapour content to condense out into fog streamers.For steam devils to form the air above the body of water must be very cold, and a fairly brisk (over 25 mph) wind of dry air needs to be blowing across the surface of the water. The temperature difference between the water and the air needs to be quite marked; the steam devils in figure 1 were forming with an air temperature of -21°C (-6°F) and a water temperature of 0.5°C (33°F) - a difference of 22°C (39°F). Under these conditions the air rises so energetically that the air flow becomes unstable and vortices start to form. Fog streamers drawn into the vortices render the vortices visible and they then become steam devils.
The steam fog tends to form irregular hexagonal cells in the horizontal plane which are elongated in the direction of the wind. In this honeycomb
Honeycomb
A honeycomb is a mass of hexagonal waxcells built by honey bees in their nests to contain their larvae and stores of honey and pollen.Beekeepers may remove the entire honeycomb to harvest honey...
arrangement, three cells will meet at a junction, and it is in these places that the steam devils form. This effect is an example of vertex vortices.
The layer of cumulus seen above steam devils during cold air outbreaks on Lake Michigan and elsewhere may not be coincidental. Airborne radar studies during cold air outbreaks on the lake have shown that some steam devils penetrate through the thermal internal boundary layer (below which convective circulation takes place) and may be more significant for thermal mixing than normal convection, transporting moist air vertically above the convection boundary. The resulting large scale view is a layer of arctic steam fog close to the water surface, a layer of cumulus just above the convection boundary and a regular array of steam devils joining the two.
Occurrences
Steam devils are seen on the Great LakesGreat Lakes
The Great Lakes are a collection of freshwater lakes located in northeastern North America, on the Canada – United States border. Consisting of Lakes Superior, Michigan, Huron, Erie, and Ontario, they form the largest group of freshwater lakes on Earth by total surface, coming in second by volume...
in early winter. They occur in the Atlantic off the coast of the Carolinas when cold air from the continent blows across the Gulf Stream
Gulf Stream
The Gulf Stream, together with its northern extension towards Europe, the North Atlantic Drift, is a powerful, warm, and swift Atlantic ocean current that originates at the tip of Florida, and follows the eastern coastlines of the United States and Newfoundland before crossing the Atlantic Ocean...
. Steam devils can occur on small lakes and even over hot springs, but rather more rarely than on large bodies of water. It is also possible for steam devils to form over wet land if the air is cold and the sun is heating the ground.
Small steam devils occur at some of the larger hot springs in Yellowstone Park where a layer of steam fog hangs over the pools and wind can start to lift it up into fog streamers. One such example is the Grand Prismatic Spring
Grand Prismatic Spring
The Grand Prismatic Spring in Yellowstone National Park is the largest hot spring in the United States, and the third largest in the world, next to those in New Zealand. It is located in the Midway Geyser Basin....
in the Yellowstone Midway Geyser Basin. The air temperature can be high in terms of human comfort when the steam devils form. In 1982 a cluster of seventeen steam devils was observed when the air temperature was between 17 and 21°C. Although this is much higher than, for instance, the temperature of the air over the Great Lakes, the water temperature is also proportionately higher, being very close to boiling, so the temperature difference is still 79°C.
Another well known location in Yellowstone, the Old Faithful geyser, produces horizontal steam devils. In all, Yellowstone probably has the most frequent occurrences of accessible steam devils anywhere, with several steam devils being produced every hour at the most productive locations. Steam devils over geyser basins were first reported by Holle in 1977.