Chopping tool

In archaeology

Archaeology

Archaeology, or archeology , is the study of human society, primarily through the recovery and analysis of the material culture and environmental data that they have left behind, which includes artifacts, architecture, biofacts and cultural landscapes...

, a chopping tool is a form of prehistoric stone tool

Stone tool

A stone tool is, in the most general sense, any tool made either partially or entirely out of stone. Although stone tool-dependent societies and cultures still exist today, most stone tools are associated with prehistoric, particularly Stone Age cultures that have become extinct...

, considered to be a refinement of the earlier chopper

Chopper (archaeology)

Archaeologists define a chopper as a pebble tool with an irregular cutting edge formed through the removal of flakes from one side of a stone....

.

Unlike the crude chopper, the chopping tool is created by removing flakes

Lithic flake

In archaeology, a lithic flake is a "portion of rock removed from an objective piece by percussion or pressure," and may also be referred to as a chip or spall, or collectively as debitage. The objective piece, or the rock being reduced by the removal of flakes, is known as a core. Once the proper...

 from two sides of a lithic core

Lithic core

In archaeology, a lithic core is a distinctive artifact that results from the practice of lithic reduction. In this sense, a core is the scarred nucleus resulting from the detachment of one or more flakes from a lump of source material or tool stone, usually by using a hard hammer percussor such...

. It is a true biface

Biface

In archaeology, a biface is a two-sided stone tool and is used as a multi purposes knife, manufactured through a process of lithic reduction, that displays flake scars on both sides. A profile view of the final product tends to exhibit a lenticular shape...

 tool although not as finely worked as the later handaxe which is worked all over its surface into a more ergonomic shape with pointed tip and rounded butt end. The cutting edge of the chopping tool is not straight as the flaking from either side gives it a sinuous appearance when viewed end-on.

Chopping tools were employed in Middle Palaeolithic industries

Archaeological industry

An archaeological industry, normally just "industry", is the name given in the study of prehistory to a consistent range of assemblages connected with a single product, such as the Langdale axe industry...

, especially in Asia

Asia

Asia is the world's largest and most populous continent, located primarily in the eastern and northern hemispheres. It covers 8.7% of the Earth's total surface area and with approximately 3.879 billion people, it hosts 60% of the world's current human population...

 where they have been found at sites such as Choukoutien.