|
|
|
|
Wow (recording)
|
| |
|
| |
Wow is a relatively slow form of flutter (pitch variation) which can affect both gramophone records and tape recorders. In the latter, the collective expression wow and flutter is commonly used.
Gramophone records
When playing gramophone records, wow is a once-per-revolution pitch variation which could result from warping of the record or from a spindle hole that was not precisely centered.
If the hole is not centered exactly, the linear velocity of the stylus, instead of dropping gradually as the groove spirals towards the center, varies every revolution to be too high (resulting in a higher pitch) when the stylus is further out, and too low when the stylus is further inwards (resulting in a lower pitch).
Discussion
Ask a question about 'Wow (recording)' Start a new discussion about 'Wow (recording)' Answer questions from other users |
Encyclopedia
Wow is a relatively slow form of flutter (pitch variation) which can affect both gramophone records and tape recorders. In the latter, the collective expression wow and flutter is commonly used.
Gramophone records
When playing gramophone records, wow is a once-per-revolution pitch variation which could result from warping of the record or from a spindle hole that was not precisely centered.
If the hole is not centered exactly, the linear velocity of the stylus, instead of dropping gradually as the groove spirals towards the center, varies every revolution to be too high (resulting in a higher pitch) when the stylus is further out, and too low when the stylus is further inwards (resulting in a lower pitch). Obviously, the more eccentric the positioning of the spindle hole, the greater the pitch variation.
The cause for "wow"-effects on a warped disc is basically the same; a variation in the linear velocity of the stylus relative to the disc. This can be by either radial warping (similar to the eccentric hole case) or by the disc warping out of its plane. This would mean that the stylus would have to travel faster over the warped section as it must displace both in and out of the plane of the disc.
Tape recorders
A similar problem can occur with tape recorders. The changes in frequency are caused by irregular tape motion during recording or playback. For example, a change in the angular velocity of the capstan, or dragging of the tape within an audio cassette shell. The terms "wow and flutter" are often referred to together, flutter being a higher-rate version of wow.
Scrape Flutter - a high frequency flutter of above 1000 Hz - can sometimes occur from the tape vibrating as it passes over a head, as a result of rapidly interacting stretch in the tape and stiction at the head. It adds a roughness to the sound that is not typical of wow & flutter, and damping devices or heavy rollers are sometimes employed on professional tape machines to prevent it. Scrape flutter measurement requires special techniques, often using a 10 kHz tone.
A typical modern cassette recorder may have a wow and flutter specification of 0.08%.
Video recording
A similar problem can also occur in videotape recordings, causing the picture to jitter slightly, or the top of the picture to wobble. This is known as flagwaving.
Correction
Novel methods of digital signal processing have been developed that correct wow and flutter by tracking various spuriae on the tape or film which can be re-purposed as timing references. A system developed by Plangent Processes substantially reduces wow and flutter of very high rates to extremely low levels, with a substantial improvement in quality.
See also
|
| |
|
|
