Dynamic recrystallization
Encyclopedia
Dynamic recrystallization (DRX) is a type of recrystallization
Recrystallization (metallurgy)
Recrystallization is a process by which deformed grains are replaced by a new set of undeformed grains that nucleate and grow until the original grains have been entirely consumed. Recrystallization is usually accompanied by a reduction in the strength and hardness of a material and a simultaneous...

 process, found within the field of metallurgy
Metallurgy
Metallurgy is a domain of materials science that studies the physical and chemical behavior of metallic elements, their intermetallic compounds, and their mixtures, which are called alloys. It is also the technology of metals: the way in which science is applied to their practical use...

. In dynamic recrystallization, as opposed to static recrystallization, the nucleation and growth of new grains occurs during deformation rather than afterwards as part of a separate heat treatment.

In a stress-strain curve
Stress-strain curve
During tensile testing of a material sample, the stress–strain curve is a graphical representation of the relationship between stress, derived from measuring the load applied on the sample, and strain, derived from measuring the deformation of the sample, i.e. elongation, compression, or distortion...

, the onset of dynamic recrystallization can be recognized by a distinct peak in the flow stress in hot working
Hot working
Hot working refers to processes where metals are plastically deformed above their recrystallization temperature. Being above the recrystallization temperature allows the material to recrystallize during deformation. This is important because recrystallization keeps the materials from strain...

 data, due to the softening effect of recrystallization. However, not all materials display well-defined peaks when tested under hot working conditions. The onset of DRX can also be detected from inflection point
Inflection point
In differential calculus, an inflection point, point of inflection, or inflection is a point on a curve at which the curvature or concavity changes sign. The curve changes from being concave upwards to concave downwards , or vice versa...

 in plots of the strain hardening rate against stress. It has been shown that this technique can be used to establish the occurrence of DRX when this cannot be determined unambiguously from the shape of the flow curve.

If stress oscillations appear before reaching the steady state, then several recrystallization and grain growth cycles occur and the stress behavior is said to be of the cyclic or multiple peak type. The particular stress behavior before reaching the steady state depends on the initial grain size, temperature
Temperature
Temperature is a physical property of matter that quantitatively expresses the common notions of hot and cold. Objects of low temperature are cold, while various degrees of higher temperatures are referred to as warm or hot...

, and strain rate.
DRX can occur in various forms, including:
  • Geometric Dynamic Recrystallization
    Geometric Dynamic Recrystallization
    Geometric Dynamic Recrystallization is a recrystallization mechanism that has been proposed to occur in several alloys, particularly aluminium, at high temperatures and low strain rates...

  • Discontinuous dynamic recrystallization
  • Continuous sub-grain rotation type dynamic recrystallization
    Continuous sub-grain rotation type dynamic recrystallization
    In Metallurgy, Materials Science and Structural geology continuous sub-grain rotation type dynamic recrystallization is recognized as an important mechanism for dynamic recrystallisation. It involves the rotation of initially low-angle sub-grain boundaries until the mismatch between the crystal...


Some authors have used the term 'postdynamic' or 'metadynamic' to describe recrystallization that occurs during the cooling phase of a hot-working process or between successive passes. This emphasises the fact that the recrystallization is directly linked to the process in question, while acknowledging that there is no concurrent deformation.

Literature

The source of this article is wikipedia, the free encyclopedia.  The text of this article is licensed under the GFDL.
 
x
OK